Question

Error Not enough nonconformance serial numbers specified

  • 25 October 2022
  • 6 replies
  • 108 views

Seeing this error when trying to save 1 qty nonconformance on a 1qty job in Data Collection. NCR was not created. Serial number confirmed toi hav 1 qty assigned. Was able to create the nonconformance from the ERP system. What does this error mean?

 


6 replies

Userlevel 4

Hi

I think that you will find that if you NC a finished product from a job you need to have assigned/created a serial number to non-conform against

Hi Sue, Not sure what you mean? The part is not a finished product yet. The operator tried to write the nonconformance on the operation prior to the final operation. The part was still in WIP on the job. The serial number was assigned to the job on 13Oct2022. The attempt to write an NCR was on 24Oct2022. What would have occured to cause this error? Please note we are new to Epicor. so seeking to understand.

Userlevel 1

Good morning, rather than doing a nonconformance as part of end labour you should do this as nc against the job wip material affected. This is automatically unallocate the material so that you can reissue a none defective part. Pick the Non Conformance from the MES Production menu and ensure when relating to a job you pick New Material NC. 

Hope this helps.

Thank you, ggedney. This won’t help because the assembly does not need a new material issued. It just needs to be reworked for an unusual visual condition. No additional materials are needed.

Do you have any insight to this error? Do you know what causes it or what it actually means?

Userlevel 1

Hi, not sure I am seeing your error correctly above on the image, it appears to be missing? If you are reworking, there is a few different ways of doing this. Could you post the error again please?

This is the error given in Data Collection when the operator enters 0 qty in current and 1 qty in nonconformance. There is no additional detail for the error.

Error Not enough nonconformance serial numbers specified

Reply