We’re a month and a half into Kinetic following upgrade from E905 - I include that for context.
I’ve tried various searches in Community to find if it’s been up before, but not found anything.
Note: all of the below has been in Classic screens
Has anybody else seen this type of behaviour?
- From Part Tracker for a standard part with a revision history I select the revision tab and click say revision 6 (the only approved revision) and right click to open Method Tracker.
- I right click a material (which I know changed from one part number to another at around rev 3) and open Time Phase
- Time Phase opens for the selected part (i.e the current part num in rev 6) and displays the standard min/max detail and say 45ea as the balance
- half a second later the part num has switched to the now retired part which was switched out at rev 3 and min/max and balance are - as one would expect for the retired part - zero and in the background Part Tracker has shifted the highlighted line from rev 6 to rev 1
If not watching the screen closely or paying attention to Part Track Rev tab in the background and noting the uncommanded switch of rev, which the screen link to Time Phase has tracked, then one could make an erroneous decision so it’s pretty dangerous...
Even odder: that process I described is what happens on my Production Manager’s PC, but on my laptop it doesn’t happen and rev 6 remains highlighted and the Time Phase detail remains correct for the correct part…
I’ve tried the magical Clear Cache on his machine to no avail.
Not sure where to go next in a) understanding quite what is going on and b) resolving so that we don’t make costly errors...