We use the backflush labor process, and need to schedule it after an upgrade, but are confused on the settings. What are the recommended scheduling settings.
Should it be set asrecurring, with a 5 minute processing delay, and connected to a startup schedule.
Should it be set as continuous and connected to a startup schedule.
Something else?
I don’t know if what we do is the recommended procedure, but we set it to run every 15 minutes. That works fine for us an is not a drain on resources.
We run it every five minutes with these settings:
What we ended up doing was to set it on an “Interval” type schedule for 5 minutes.
the process was set: Not as Continuous, and Yes, set as Recurring
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.