We have thousands of part in Inspection Processing where processes have not been followed correctly in the past, We need to remove all of these and was wondering if there is a simple way of doing this, it quite literally is looking for a way to purge the lot.
Hi
Hi Scott
To be honest that could be anybodies guess, that is the issue. The processes have not been followed in any sense of the word and i need to start looking at clear up of data for when we move to E10. Quality Processes seem to have not been followed (If there were ever any to follow) and data integrity is poor across a lot of areas. It looks as though on a couple i have looked at this morning that PO Receipts seem to have gone into inspection but the process has never been followed through. These could have been either to stock or job receipts and a lot of them are many years old.
Daniel
We had this happen with first inspections. We requested a delete fix from Epicor support and they were able to clear them.
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.